Change the wpa-ssid value in the quotes to your network's ssid (your wireless network name) and be sure it is still surrounded by quotes. Navigate to your network interfaces with the following command: sudo nano /etc/network/interfaces Erase all the text and copy and past the code you see below: auto lo iface lo inet loopback iface eth0 inet dhcp allow-hotplug wlan0 auto wlan0 iface wlan0 inet dhcp wpa-ssid "ssid" wpa-psk "password" *it should appear as the image below. * I also do not recommend overclocking your Pi for this project, the default setting works perfectly and overclocking will reduce the overall lifetime of the hardware. Panda wireless raspberry pi update#Do not update your Raspberry Pi at this point (we need to configure the wireless USB module first) - Do not restart your Raspberry Pi at this time. Disable boot to desktop, we want to configure this program using only the terminal environment. Enable SSH server (so you can control pianobar with your mobile device as well as continuing this installation on your desktop or laptop via SSH). Here you should make the following changes: - Expand root partition so all space on the SD card is usable. You do not need to know what it all means for this project, but I absolutely wouldn't discourage you from reading it and learning a little bit about your Raspberry Pi for your own benefit! After the boot information is complete, you will be prompted with the raspi-config window. Upon powering the Raspberry Pi with the SD card plugged in, you will see the system automatically listing information about the operating system and peripherals. Keep in mind, if you mess up anything along the way, just reformat your card, reload the disk image and start again.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |